Sensors are retained with a bush next to the lens: where this is visible, ensure that you spray into the lens (arrowed), not the bush.
  1. Direct the airduster into the openings arrowed and spray liberally.

    1. Open the perspex top cover and raise the collate clamshell (closest to the envelope hopper) so that it locks in place.

      Picture shown is viewed looking inside the collation area towards the envelope hopper.

      1.   
    2. Picture is viewed looking inside the collation area away from the envelope hopper.

      Clean all sensors arrowed.

      1.   
    3. Lower the collate clamshell and open the upper conveyor (furthest from the envelope hopper) so that it locks in place.

      Picture is viewed looking inside the collation area away from the envelope hopper.

      Insert the airduster nozzle deep into the hole and spray liberally. Note the the upper sensor half is not easy to see and is mounted on a bar.

      Lower the conveyor.

      1.   
    4. Lower the side cover and raise the overguide inside the closer cavity, latching it in place.

      Clean the sensors arrowed.

      1.   
    5. Picture is viewed looking down on the envelope hopper, at the front.

      Clean the one-piece reflective sensor.

      1.   
    6. Open the side cover and lower the front output cover below the envelope feeder.

      Clean the one-piece reflective sensor.

      1.   
Date created:
03/12/2013 07:39:55
Last updated:
03/18/2013 08:17:45
Product(range):
DS-200
Print